Building libxfcegui4 with dbh 4.2beta1 CVS

[edscott wilson garcia]

El mié, 13-10-2004 a las 19:57, Peter N. Spotts escribió:
> Folks,
> 
> I've compiled the latest CVS version of 4.2beta1 and all is well -- except for xfrun4. When I run it from a menu, nothing happens. When I run it from a command line, I get the following error:
> 
> Cannot work with combo module: libxfcegui4 constructed without libdbh. Aborting
> 
> I recall installing libdbh (from a Fedora rpm), did a locate, and found the lib. I then reconfigure libxfcegui4, paying special attention to help options regarding the lib. Didn't find anything that looked like --enable-dbh, so I ran ./configure and went back over the echo lines after it was finished. The configure program found libdbh and it was the right version. So I ran make/make install, ran xfrun4 again, and it still failed with the same error message. I'm missing something, I'm sure...
> 

It's the chicken and egg thing here. Try doing make clean for both
libxfcegui4 and xfce-utils to get a fresh start. The dependency problem
you encountered has been fixed for 4.2beta2.

regards,

Edscott