Building libxfcegui4 with dbh 4.2beta1 CVS

[Peter N. Spotts]

Folks,

I've compiled the latest CVS version of 4.2beta1 and all is well -- except for xfrun4. When I run it from a menu, nothing happens. When I run it from a command line, I get the following error:

Cannot work with combo module: libxfcegui4 constructed without libdbh. Aborting

I recall installing libdbh (from a Fedora rpm), did a locate, and found the lib. I then reconfigure libxfcegui4, paying special attention to help options regarding the lib. Didn't find anything that looked like --enable-dbh, so I ran ./configure and went back over the echo lines after it was finished. The configure program found libdbh and it was the right version. So I ran make/make install, ran xfrun4 again, and it still failed with the same error message. I'm missing something, I'm sure...

Pete

-- 
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
     Peter N. Spotts | Science Correspondent
          The Christian Science Monitor
       One Norway Street, Boston  MA  02115
Office: 617-450-2449 | Office in home: 508-520-3139
  Email: pspotts at alum.mit.edu | www.csmonitor.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~